Industrial piercing in Bali
Industrial piercings at Amor Fati cost IDR 1.300.000 at our three Bali studios in Canggu, Uluwatu and Seminyak, titanium bar and tax included. Two holes in the upper ear share one bar, so it is among the most painful we do, 4–5 out of 5, and heals in 9–12 months or more.
About the industrial
An industrial is two piercings in the upper ear joined by a single straight barbell, usually running from near the front of the ear across to the outer rim. The two holes have to line up exactly, because the bar is rigid and will press on any point that is out of line.
That makes it one of the most anatomy-dependent piercings we offer. If your ear cannot take two aligned points without the bar pressing, we will not do it, and we may suggest a helix with a forward helix or a flat for a similar look.
Aftercare for this placement
- Sleep on the other side until it has fully healed
- Take hats, hair ties and helmet straps on and off with care
- Clean both holes for the full 9–12 months; they can heal at different speeds
Good fit if
- Your upper ear has room for two aligned points (we will check)
- You can accept a long heal
- You want a bold, graphic line across the ear
What to expect
Pain
About 4–5/5 compared with a lobe
Downsize
Checked at 4–6 weeks, once the swelling has gone
When we say no
Ear anatomy does not allow two correctly aligned points without pressure from the bar.
Pain is personal, so scores are estimates; your piercer checks your anatomy before anything is marked. Prices and healing times checked Nov 2026.
Questions about the industrial piercing
Does an industrial piercing hurt?
It is one of our two most painful piercings, about 4–5 out of 5 where a lobe is 1, because it is two cartilage piercings in one visit.
How long does an industrial take to heal?
9–12 months, often longer. Each hole heals at its own pace, and the bar moves both when one is knocked, so it is the slowest ear piercing we do.
Can anyone get an industrial piercing?
No. It needs an upper ear where two points line up without the bar pressing on the cartilage. Our piercer checks this first and will say no if it does not.
How much is an industrial piercing in Bali?
IDR 1.300.000 at Amor Fati for both holes and the bar, with implant-grade titanium and 11% tax included, the same at all three studios. The piercer checks your ear first.
Can I sleep on an industrial?
Not while it heals. A rigid bar under pressure pushes on both holes at once, so sleep on the other side through the 9–12 months it takes.
How long is an industrial bar?
Usually 32–38 mm at 14 gauge, measured to your ear on the day. A bar that is too short pulls on both holes; one that is too long catches on hair and hats.
General aftercare, not medical advice: more red, swollen or sore after the first days? Come in or see a doctor, jewellery in. Routine: piercing healing guide.
Other placements
Wondering what to get next?
Tap a placement to see it on a real ear, with how long it actually takes to heal.


On the small ridge at the front of the ear, facing forward.
Heals 6–12 months
Single-use needles, never a gun
A sterile single-use needle for every piercing, jewellery sterilised in our autoclave, walk-ins welcome at all three studios (open daily 9am to 9pm in Canggu and Uluwatu, 9am to midnight in Seminyak), rated 5.0 on Google across 2,298 reviews (counted Nov 2026). Aftercare in full: the piercing guide. Every placement and price: the piercing page.
How we work
One straight bar, measured to your ear
An industrial is fitted with a titanium straight barbell, 14 gauge and usually 32–38 mm long, measured so it sits without pulling on either hole. If it was cut long for swelling, a piercer shortens it at 4–6 weeks. Other bars wait until both holes have fully healed.
Healing & downsizingService prices
Per piercing, with implant-grade titanium and 11% tax included, at all three studios.

Book an industrial piercing
Tell us which studio suits you, and we will mark your industrial with you at the mirror before anything happens.





































